Das-audio Variant Series Systems Guide Manual de usuario descargar pdf (Pagina 12)

System installation using the wall support AXW-V25

M8X30 DIN965

Rubber washer

M8x35 DIN 912

Grower washer

Metal washer

In order to hang the rest of the boxes the

captive rigging hardware and safety pins will be

used, and the procedures described on the 4.3

paragraph of this manual will be followed. The

picture below shows three units fixed to

the wall.

variant 25A

Three different washers must be used along

the M8x35 DIN912 screws and placed in the

following order- grower (lock) washer, metal

washer and rubber washer.

Warning!! If three units have to be

hung it is advisable to fix the box in the middle to

the wall mount accessory.

variant 25A

Then hang the first unit from the

wall mount accessory. The two M8x30 DIN965

screws have to be removed from each side of the

box and replaced by two M8x35 DIN912 screws.

variant 25A

Up to three units can be wall

mounted by means of the accessory.

First the accessory must be fixed to the wall,

making sure in advance that the work load of the

wall allows for it. The wall mount accessory will be

attached to the wall using six nº 10 rawlplugs and

six 7 x 40 mm screws.

variant 25A

AXW-V25

variant S uideystems G

1 2 ... 7 8 9 10 11 12 13 14

Sin comentarios

Das-audio Variant Series Systems Guide Manual de usuario Pagina 12